Verification
Verification
After carrying out the repair, check that the fault has been remedied.
Ignition off.
Reconnect connectors, reinstall components.
Ignition on
Read off throttle position (TP) sensor voltage.
The value of THROT POT should be approximately 500-800 mV and the value of IDLE SW should be ON when the accelerator pedal (AP) is in its highest position.
The value of THROT POT V should be 4.8-5.1 V when the accelerator pedal (AP) is in its lowest position and the value of IDLE SW should be OFF.
Вопрос
Are these values OK?
diagnostic · VCC-108478-1
Verification After carrying out the repair, check that the fault has been remedied. Ignition off. Reconnect connectors, reinstall components. Ignition on Read off throttle position (TP) sensor voltage. The value of THROT POT should be approximately 500-800 mV and the value of IDLE SW should be ON when the accelerator pedal (AP) is in its highest position. The value of THROT POT V should be 4.8-5.1 V when the accelerator pedal (AP) is in its lowest position and the value of IDLE SW should be OFF. Are these values OK?
diag:servinfosub · VCC-108477-1
Signal faulty Checking throttle position (TP) sensor function Ignition on. Read off throttle position (TP) sensor voltage. The value of THROT POT should be approximately 0.5-0.8 V and the value of IDLE SW should be ON when the accelerator pedal (AP) is in its highest position. The value of THROT POT V should be 4.5-5.1 V when the accelerator pedal (AP) is in its lowest position and the value of IDLE SW should be OFF. Are these values OK? ru-RU0900c8af8091998f#KC02515428 ru-RU0900c8af8091998f#KC02515424 Checking connectors Ignition off. Check control module and throttle position (TP) sensor connectors for contact resistance and oxidation and remedy according to ru-RU0900c8af80be4147#KC0110636